[Techtoolslist] Bytek Fireman 8x

[Cameron Rector]

Hello all,
  I am new to this site, so I will applogize for dumb questions up front.
   
  I have a Bytek fireman 8x and I am having trouble programming TMS2532A's. The programming part goes well until verify. It seams that at address 0800h it fails. It does this on every chip I try. I don't know if this could be a configuration setting or it the unit has a bad solder joint or IC. I did a visual inspection from A11 pin 18 back through the circuit traces and joints, however I didn't find anything wrong. I tried to call Bytek and their phone is disconnected and my email bounced back.
   
  So, does anyone here know anything about this machine? Does anyone know where I can get the schmatic's for this programmer?
   
  I am a newbe at programming eproms, so don't overlook the fact I could have a software setting wacked out.
   
  The first verify error says "ADDS 0800h   Ram 01   Device 00"  
   
  Thanks in advance for the help,
  Cameron
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://seven.pairlist.net/pipermail/techtoolslist/attachments/20060930/42a9576c/attachment.html