[Techtoolslist] Changing mains voltage for power supply PSU on the Fluke 9020A

[Nigel Williams]

In the interest of saving someone else a little time, if you need to
change the line-voltage on the Fluke 9020A micro-tester then refer to
the following pictures:

http://imgur.com/a/Im6bF#0

In the final picture are two slide switches in the lower middle, on
the PCB there is an indication of the voltage options and you can
adjust the switches, for 240V I swapped them from how they appear in
the picture (which was how they were set for 110V).

Safety-first, don't try this at home without supervision etc unless
you know what you're doing.