[Techtoolslist] Logic analysis and the Atari Test connector?

[Alex Yeckley]

I have used both approaches.  The "glomper clip" approach worked out better for me, but usually required replacing the original CPU socket first.  YMMV.

-----Original Message-----
From: Techtoolslist <techtoolslist-bounces at flippers.com> On Behalf Of davids at oz.net
Sent: Wednesday, May 24, 2023 3:59 PM
To: Technical Tools Mail List <techtoolslist at flippers.com>
Subject: [Techtoolslist] Logic analysis and the Atari Test connector?

I have a missile command board which using the fluke 9010 passes all memory and rom tests perfectly.  Also can exercise the pokey with no problem.

 

But when I try to go to UUT the game just starts to make an explosionish
sound and then watchdogs.   Game mode and test mode.

 

Verified the WD is working correctly.

 

So my next thought was to connect the 16702B to the CPU address and data lines and see if I could figure out where the startup goes off the rails.
Not supper excited about having to use the test clips on 16 bits of address,
8 bits of data and misc other signals.

 

Realizing there is that nice juicy edge connector right next to the CPU I was thinking about having an adapter board made that would have and edge card and then a set of pod connectors that I could just plug the pod cables into directly.

 

Am I reinventing the wheel here?  Anyone done this and have any gotchas to mention?

 

Or am I over thinking this and should just get a 40 pin glomper clip and attach to the top of the CPU? And connect to that?

 

David

_______________________________________________
Techtoolslist mailing list
Techtoolslist at flippers.com
https://pairlist7.pair.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/