[Techtoolslist] Fluke 9010A Input voltage

[Filip Hautekeete]

Hello Steve,

You are correct. Thanks to John Robertson I figured out there is a slide card for voltage selection behind the fuse panel. No need to drag the systems out of your garage ;-)

Thanks for your help!

Filip
  ----- Original Message ----- 
  From: Steve C 
  To: 'Technical Tools Mail List' 
  Sent: Monday, October 31, 2005 8:52 PM
  Subject: RE: [Techtoolslist] Fluke 9010A Input voltage


  There *must* be something on the outside, I bought two 9010a's from the US and I certainly didn't open the case to change the voltage!  My 9010a's are in the garage loft at the moment, and there's a car in it so I can't drag either out to check!



  Is there one of those rotate to voltage type things?  Maybe it's the 9100a that has a plastic cover and plug to change the voltage? 



  -----Original Message-----
  From: techtoolslist-bounces at flippers.com [mailto:techtoolslist-bounces at flippers.com] On Behalf Of Filip Hautekeete
  Sent: 31 October 2005 19:08
  To: Technical Tools Mail List
  Subject: Re: [Techtoolslist] Fluke 9010A Input voltage



  Steve,



  There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.



  Best regards,



  Filip

    ----- Original Message ----- 

    From: Steve C 

    To: 'Technical Tools Mail List' 

    Sent: Monday, October 31, 2005 7:59 PM

    Subject: RE: [Techtoolslist] Fluke 9010A Input voltage



    Yes, there is a panel on the back that allows voltage selection - I can't remember how but it was easy.


    Steve



    -----Original Message-----
    From: techtoolslist-bounces at flippers.com [mailto:techtoolslist-bounces at flippers.com] On Behalf Of Filip Hautekeete
    Sent: 31 October 2005 13:27
    To: techtoolslist at flippers.com
    Subject: [Techtoolslist] Fluke 9010A Input voltage



    Hi all,



    Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?



    Best regards,



    Filip


----------------------------------------------------------------------------

    _______________________________________________
    Techtoolslist mailing list
    Techtoolslist at flippers.com
    http://seven.pairlist.net/mailman/listinfo/techtoolslist



------------------------------------------------------------------------------


  _______________________________________________
  Techtoolslist mailing list
  Techtoolslist at flippers.com
  http://seven.pairlist.net/mailman/listinfo/techtoolslist
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://seven.pairlist.net/pipermail/techtoolslist/attachments/20051031/3787c576/attachment.htm>